How to handle Rejected Bottles?, Recycle - Kenplas Discussion Forum

Kenplas Forum ==> Recycle ==> How to handle Rejected Bottles?

Dear sir,
I looking for Extruding RPET bottle to make belt?
what is the belt maker machinary from flake PET bottle ?
Can we use a EXTRUDER that is use for PP or PE(polyethylen) for extruding PET?
Best Regards

2005-9-8 22:13:08 By Behrooz

I am planning a PET washing operation and am concerned about the possible dangers of a high final Ph due to the use of Caustic Soda. Rinsing water might have to be neutralised. Is there any danger to this?

2005-6-22 22:02:46 By MAHENDRA

It is possible to use regrind back into bottles. Care and attention is required because of PET dust and contamination. Please also be aware that the IV of the regrind will be lower than that of the original material.

2005-6-22 22:02:26 By Technical

I AM MANUFACTURING PET BOTTLES IN WHICH I HAVE BIG LOT OF REJECTED BOTTELS.
I WANT TO USE THIS BOTTLES (AFTER CRUSING IN SMALLCHIPS)IN MANUFACTURING UNSATURATED POLYESTER RESIN.ONE WHO KNOW THE PROCESS OF USING PET WAST IN THE UP RESIN PLEASE SEND DETAIL OF PROCESS I WILL BE THANKFULL TO HIM.
THANIKIGN YOU,
YOURS TRULY.

2005-6-22 22:02:04 By MAHENDRA


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2025 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.