Visitor No.2911100 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Injection Molding (Machine) ==> Preform Bending after Heating (Wall thickness variation)
<< Previous Topic Next Topic >>
1
cause: preform bent
1.Injection core may have bent.
2.Uneven preform temperature.(UNEVEN WALLTHICKNESS)

Fine
3
Poor
2010-9-22 13:55:16 By sasikumar
the preform is good the preform is bent after the last stage of heating and before blowing

Fine
Poor
2009-3-5 21:41:23 By elbadawy
First make sure the preforms are rotated evenly while heating.

Cause: Preform off-center.

1. Poor machine condition. Check machine level, tie bar alignment;
2. Injection pressure too high;
3. Poor mold condition, contact mold maker.

Fine
9
Poor
4
2006-2-15 11:49:36 By Kenplas
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:



Message:

(Max. 2KB)





Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.