|
Kenplas Forum ==> Blow Molding (Machine) ==> Evident Mold Half Line on Bottle
|
|
|
1 |
1. (If mold thickness variable) MOLD-ADJUST should be performed for each mold installed;
2. (If mold thickness fixed) Check the thickness of mold is within the tolerance of rated mold thickness;
3. If mold is opened by blowing pressure, that means clamping force is not enough; Make sure blowing pressure used is within the blowing pressure range of the machine.
|
1 |
|
|
|
This forum published since July 03, 2002.
Renewed on June 22, 2005. |