| 1 |
1 - pet blow Machine VS-600, serial nº 200789, ------- Need you send to us the certificate with good quality by email like we send in atach.
1 - chiller Model KLA_3, serial nº 270712626, ------- Need the manual and certificate of conformity
1 - high pressur compressor Model STA155,SERIAL Nº 20053
1 - Auto Load pre forms, ------- Need the manual and certificate of conformity
Please send for us The Manual of each machine and Certificates of conformity, also tell us email of your comercial saller to send prices for Moulds and others.
Best Regards,
Rui Silva
|
Someone has the machine instruction manual in pdf Kenplas VS600
If someone can send thank you very much Email: luis.povoa@petrovagos.pt
Thank you
|
The top solenoid is quite warm. Is this normal or could it be part of the problem?
Yes, it is normal.
|
Bybass Valve
If using one high pressure air compressor, just switch on the valve shown as enclosed, then switch off the gate valve for low pressure air inlet.
|
|
Bottom Mold Installation
|
|
When temperature inside heating tunnel reaches this temperature setting, exhaust blowing fan will be triggered. Temperature shown in RED is the real temperature inside heating tunnel (e.g. 112), and temperature show in GREEN is setting temperature (e.g. 24).
|
Also inside the electic board there is a unit where you can set a temperature? What is this for?
|
Up On: 8 zone heating.
0: 4 zone heating.
Down On: 10 zone heating.
|
|
Inside the electic board there is a switch with Up ON middle 0 and down ON. What is this for please?
|
Three reasons:
1. Under automatic mode, if no preform detected (blowing signal), MOLD-CLOSE will not come. Thus if the photo sensor (blowing signal) doesn't focus on preform well, which will lead to same problem.
2. If focus length of this photo sensor is too far, it may detect the mold platen, thus mold may close one cycle and idle one cycle even there is no preform.
3. Reduce the air flow a little bit through two throttle valves shown in attached photo.
P.S. On this photo sensor, GREEN light is power indicator, and RED light is on when preform is detected.
|
|
While the machine working without blowing the mould does not close at each time. it closes one by one. Is this normal?
|
|
when machine starts, "preform rotation" starts. Rotation chain runs clockwise if view from top. Chain speed is fixed.
|
We receive today the machine and the impressions at the begining are very nice. Please send us the parametres for the trial of 5lt and 10lt.
Also we want the temperatures and the parameters of the programm.
What is the rotation of the preform because from the manual I can not understand it. Please see figure 'rotation'. Can the speed of preform potation be adjusted or it is stable?
|
| 1 |
Discussion Forum