PART DESIGN -- DRAFT, Injection Mold - Kenplas Discussion Forum

Kenplas Forum ==> Injection Mold ==> PART DESIGN -- DRAFT

To improve part ejection, draft angle should be provided on the inside and outside of part walls in the direction of draw. A draft of 1° per side is adequate for most part designs.

2005-6-29 21:05:43 By Kenplas


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.