Visitor No.2910446 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Blow Molding (Machine) ==> Pin Hole leaks in 2 oz PET bottle
<< Previous Topic Next Topic >>
1
have you checked cooling around gate area.also vp point might be too early

Fine
Poor
2015-3-16 3:17:58 By graham
We have been blowing 2 oz PET bottles we have random pinhole leaks show up off and on, trying to figure it out.
Items we have tried
Stretch rod tip design
Processing parameters
Machine processing combinations
PET processing combinations - temp control - speed -pressures etc
upon close examination pinhole is in gate area always, sometimes as a minute hole, sometimes of a crack in gate area.
We are catching with leak detection but would prefer not to make them
We are blowing PET with White colorant.

Fine
1
Poor
1
2014-5-25 20:10:51 By gregory gaines
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:



Message:

(Max. 2KB)





Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.