Gate Strings, Injection Molding (Machine)

Kenplas Forum ==> Injection Molding (Machine) ==> Gate Strings

1. Tip/Manifold temperature too high;
2. Poor valve gate operation if applicable;
3. Poor heat insulation at gate area;
4. Decompression time too high;
5. Holding pressure/Time too high;
6. Mould cooling time too low;
7. Reduce back-pressure on injection machine;
8. If open nozzle used on injection machine, turn on SUCK-BACK function (2.0mm).

2006-2-15 11:53:34 By Kenplas


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.