Milky Bottle, Blow Molding (Machine) - Kenplas Discussion Forum

Kenplas Forum ==> Blow Molding (Machine) ==> Milky Bottle

1. Heating temperature too low. Increase heating temperature/voltage for related zones. Common preform temperauture for blowing: 80~110c.

2. (Milky appears at corner area usually) Stretch ratio too high.

3. Moisture too high in compressed air.

2006-2-15 15:04:50 By Kenplas


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.