Visitor No.2910354 ..   
TrustPassKenplas Industry Ltd.Discussion Forum
 
Kenplas Forum ==> Injection Molding (Machine) ==> MILKY PREFORM
<< Previous Topic Next Topic >>
1
I suppose you could ask them to make them for you, [b][url=http://www.moldbustersllc.com/mold-remediation/]Mold remediation in Maryland[/url][/b] I was planning on sodden the filter.

Fine
Poor
2015-4-16 14:37:51 By mold
I am facing white mark at bottom of the preform(near Gate Point)

Fine
10
Poor
2
2012-8-4 19:31:15 By k karthigeyan
sir i make pet prefir from pet resin graunals. My olding machine have five heating zone i want to know about zone temp. setting. Sir also want any prolem solution as shrinke, milky preform, cut peice of preform etc.

Fine
8
Poor
3
2010-9-13 15:56:53 By arjun
1. Check drying condition of PET resin;
2. Check if any heater (mold & machine) is burnt.

Fine
13
Poor
4
2007-12-26 20:49:58 By (Anonym)
before has be make preform and have not problem(clear)but now preforms are milky. I think pet chips have problem because they dont change any setting. what your idea?

Fine
22
Poor
6
2007-12-26 19:58:21 By moridi
1
 
 

Post A Reply

Temporarily shut down, no new message, sorry.

Name:

Email:



Message:

(Max. 2KB)





Attachment:     (Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project] [Plastics Machinery] [Plastics Mold] [Discussion Forum] [Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd.              Powered by Alentus.