| 1 |
|
White misty colour on sides at bottom end even when pre-blow(LP blowing)is minimised and temperatures optimised.Air delay time were increased. We have a 3 botlle mould machine. Two bottles(24g variants)comes out perfectly while the third leaves the misty white colour that I refered to in the beginning.Like to here from you a.s.a.p.
|
|
hello sir plz tell me abt the second hand blow moulding machice cost
|
21-12-2011
Hello
I want second hend plastic bottel blow moulding machine
and mould.
Mr. Atulkumar
( Tanzania )
|
Dear sir
need ur help
i used the streach blow molding can u tell me temp set point our prefrom 40 gram jar lanth 50mm dia 40mm waht i sent point heater befor blowing prefrom i have chaines machine
BR
nadeem Ahmad
|
|
Pl. check the stretch rod tip first. Also adjust the pre blow as the gate point coming in the centre
|
|
You must install Preferential Heating System just before the prefomrs enter the blowing molds.
|
|
when i produced oval Bottel, wall thickness not Uniform in each sides?
|
| 1 |
Discussion Forum