Bottle Bottom too Thin/Thick, Blow Molding (Machine) - Kenplas Discussion Forum

TrustPass

Kenplas Industry Ltd.

Discussion Forum

　

Kenplas Forum ==> Blow Molding (Machine) ==> Bottle Bottom too Thin/Thick

<< Previous Topic

1

	too Thin	too Thick
Heating temperature for preform bottom	too high	too low
BLOW-DELAY Time Setting	too short	too long
PRE-BLOW pressure	too high	too low

Fine

1

Poor

2006-2-15 15:15:45 By Kenplas

1


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.