Bottom Bottom Bursts Easily while Dropping, Blow Molding (Machine)

Kenplas Forum ==> Blow Molding (Machine) ==> Bottom Bottom Bursts Easily while Dropping

1. Preform bottom is not well stretched (too thick or too thin);
2. Preforms are made of depolymerized PET resin. Make sure PET resin is properly dried, and lower injection temperature is applied.

2006-2-15 15:52:41 By Kenplas


*Post A Reply*
	Temporarily shut down, no new message, sorry.
Name:	..Invalid Name..
Email:	..Invalid Email.. Send new posts of this topic to my email box.
Message:	(Max. 2KB)
Message:	..Invalid Message..
Attachment:	(Max. 500kB, .RAR.ZIP.JPG.GIF only)
Verification:	..Invalid Code..

This forum published since July 03, 2002. Renewed on June 22, 2005.

[Plastics Project]	[Plastics Machinery]	[Plastics Mold]	[Discussion Forum]	[Contact Kenplas]
Copyright © 2024 Kenplas Industry Limited, Hangzhou Kenplas Machinery Ltd. Powered by Alentus.